shaun . . he is not going to use the reverse lites because his reverse lite switch is bad so these will be blinkers only
I've been thru this all before, Shaun posted these instructions years back and prob a few times since.
Barnett that wiring mod knocks out your proper brake lights and in effect your 'reverse lights' now become brake/turn signal.
thats why you must do the crossover at the brake pedal switch as well, to separate the brake and turn signal from eachother.
Here's the mod:
- disconnect the reverse light bullet connector (black/red wire) that pokes out the top of the kick panel near fuses. tape off the female connector of that and tuck it away, as youll then join the new wire to the male connector.
cut the green wire at the stop light switch, tape off the end that goes into the loom, then extend the other short green tail from the switch with a new wire to that reverse light male connector (i made a new wire with bullet connectors for easy connection) This re-routes the brake light power rather than it going through the turn signal switch.
- at the tail lamps cut the orange/blue & green/orange brake&turn signal wires from their respective tail/brake lamp holders, connect them to the black/red wire that goes to their respective reverse light beneath. This will give you indicators in reverse lights.
connect the incoming black/red wires to those turn signal tails that were cut at the brake lamp holder. You now have brake lights. In case you wondered, the tail lamp signal is the plain black wire which remains unchanged.