Author Topic: Clutch cable to firewall entry point (Read 4320 times)

ray_aus · « **on:** September 19, 2011, 09:45:56 am »

I need to know if anyone with a 2001 cobra has a teflon spacer between the end of the clutch cable and the firewall as my clutch is gripping on the top of the release and I am not sure if this was placed as a after market item
It is the white teflon as seen on the image attached.
Thanks in advance.

66 Hertz · « **Reply #1 on:** September 19, 2011, 10:17:44 am »

no image?..........:banghead:

jiffy · « **Reply #2 on:** September 20, 2011, 12:06:33 pm »

Yup, sure has - the end of the black cable fits into it and then the white part goes through the firewall.

Having problems with your clutch? - having the same issue with my 2002 Cobra, happy to talk...

jiffy · « **Reply #3 on:** September 29, 2011, 01:37:43 pm »

Try taking the split pin out of the shaft the cable U-clip sits on. It rests on two little yellow bushes.
REmove them all, grease the shaft and reassemble - see if that's any better.
Get a can of WD-40 with the little red tube that allows you to spraya small surface at a distance. Spray the end of the cable where it goes into teh sheath through the firewall - see if either of these improve the movement....

Clutch cable to firewall entry point

News:

Author Topic: Clutch cable to firewall entry point (Read 4320 times)