Hey guys,
Need to take a run to the nut and bolt shop but need thread type and size for the three bolts that hold the slave cylinder to the chasis. This the mounting bracket that goes just near and the steering box. Alas my old ones have got lost in the rebuild. Dont feel like spending $220 for a master body kit when all I need is three bolts. Two look to be same size but the third one is smaller. Any measurements woud be great especially thread type as they need to screw into the female threaded holes on the chasis so got get this right. Do they need to be high tensile as i reckon there i not much load on them?
thanks
Clinton
