Bonnet rubbers

Mustang Australia
« previous next »
Pages: [1]   Go Down

Author Topic: Bonnet rubbers  (Read 1561 times)

Offline Woz

  • Pony
  • **
  • Posts: 35
  • I'm new here
  • Location: Gold Coast
Woz
Bonnet rubbers
« on: January 16, 2021, 12:16:03 pm »
How the hell do you fit the bonnet rubbers 68 near the windscreen on the gard.
Tried heating (boiling water) rubber grease WD40 and bought needle nose angle pliers, still won’t go in.
Please help
Logged

Offline motiv

  • Pony
  • **
  • Posts: 20
  • I'm new here
  • Location: Vic
motiv
Re: Bonnet rubbers
« Reply #1 on: January 17, 2021, 10:00:09 pm »
Well, one way you could do it is, remove your front wheel, remove your splash shield if you have one. Grip your bonnet rubber from underneath with your pliers and pull down while moving your pliers left to right a bit as your pulling.
Logged

Offline Woz

  • Pony
  • **
  • Posts: 35
  • I'm new here
  • Location: Gold Coast
Woz
Re: Bonnet rubbers
« Reply #2 on: January 23, 2021, 06:08:02 pm »
Many thanks for your replies.

Finally got them in, had to be a custom fit,
Timed 1-2mm of the edges, applied WD40,
Pushed from the top back and forth, they slipped in.

Thanks
Woz
Logged
Pages: [1]   Go Up
« previous next »