68 mustang intake

Mustang Australia
« previous next »
Pages: [1]   Go Down

Author Topic: 68 mustang intake  (Read 3173 times)

Offline AussiePhil

  • Worked
  • ***
  • Posts: 786
  • Location: Bathurst, NSW
  • Name: Phil
  • Car: 68 Coupe
AussiePhil
68 mustang intake
« on: June 03, 2019, 04:14:58 pm »
[img]<a href='https://postimg.cc/QV64pQW4' target='_blank'><img src='https://i.postimg.cc/QV64pQW4/20190505-084140.jpg' border='0' alt='20190505-084140'/></a>/img]
Logged
If you've never buggered anything you've never done anything!
But if you've buggered a lot maybe you're not very good at it!

Two for one is good but four for two is better!

Offline AussiePhil

  • Worked
  • ***
  • Posts: 786
  • Location: Bathurst, NSW
  • Name: Phil
  • Car: 68 Coupe
AussiePhil
Re: 68 mustang intake
« Reply #1 on: June 03, 2019, 04:15:59 pm »
Hi, after some time looking for an Edelbrock ED7128 without luck I've fitted an Edelbrock ED29285 intake manifold and an Edelbrock low profile elbow ED3847.

It's come out great.

I needed to also use a low profile distributor,  in this case an ICE 8+1 camshaft sensor.

Just thought you like a look.
Cheers Phil.
Logged
If you've never buggered anything you've never done anything!
But if you've buggered a lot maybe you're not very good at it!

Two for one is good but four for two is better!
Pages: [1]   Go Up
« previous next »