Mustang Owners Club Australia Forum

Technical & General Discussion Area => Tech Torque Pre 1973 => Topic started by: mswyld on June 07, 2006, 02:43:16 pm

Title: 289 windsor
Post by: mswyld on June 07, 2006, 02:43:16 pm

currently have a 289 windsor with a 3spd manual (has the old style clutch linkages through the firewall) and is left hand drive!

I was looking at getting the motor reco'ed......

but stumbled across a 289 windsor with a 4spd manual out of a za fairlane which has not long been done up has roller rockers edelbrock bits etc etc

what would i need to change in order to fit the 4spd and motor:  

tailshaft?
clutch manual linkages?

or would it slot straight in?

THANKS IN ADVANCE!

Title: 289 windsor
Post by: dta308 on June 08, 2006, 03:26:28 pm

You will not need to change absolutely anything else, It should all line up as if you are refitting the 289 with the 3 speed.