1
Restomods / Re: Rusty 66 Coupe
« Last post by Rayatswan on Yesterday at 08:28:45 am »Engine bay welding finished
Recent Posts
News:
Recent Posts
2
Tech Torque Pre 1973 / Re: 67 S-code is dead - no electrical activity
« Last post by 6t9m1 on September 27, 2023, 08:57:05 pm »Check the earth connections.
There should be at least two, one from the negative battery post to the engine block and another from the engine block to the body.
i.e. remove and check for corrosion then if found clean and resecure.
There should be at least two, one from the negative battery post to the engine block and another from the engine block to the body.
i.e. remove and check for corrosion then if found clean and resecure.
3
Restomods / Re: Rusty 66 Coupe
« Last post by Rayatswan on September 27, 2023, 01:15:54 pm »Thanks Tony and Mark, appreciate the comments.
4
Restomods / Re: Rusty 66 Coupe
« Last post by mwizz on September 27, 2023, 10:29:18 am »Love your work, very informative
5
Tech Torque Pre 1973 / Re: 67 S-code is dead - no electrical activity
« Last post by RocketScientist on September 27, 2023, 10:26:28 am »My instance killed everything - not the best thing when you're at the servo trying to fill up. 
At the time I put it down do the starter solenoid or the switch and firstly replaced the solenoid as it was the easier thing to do. After finding no change, replacing the switch fixed everything. 
At the time I put it down do the starter solenoid or the switch and firstly replaced the solenoid as it was the easier thing to do. After finding no change, replacing the switch fixed everything. 6
Tech Torque Pre 1973 / Re: 67 S-code is dead - no electrical activity
« Last post by pmb0186 on September 26, 2023, 07:50:18 pm »Interior light, horn, cigarette lighter should work ignition on or off
7
Tech Torque Pre 1973 / Re: 67 S-code is dead - no electrical activity
« Last post by RocketScientist on September 26, 2023, 06:42:26 pm »I had a worn ignition switch on my 67 do that to me - turn the key and it shut everything down.
8
Tech Torque Pre 1973 / Re: 67 S-code is dead - no electrical activity
« Last post by pmb0186 on September 25, 2023, 10:39:45 pm »Agree with solenoid worth checking.
Next voltage reg, bulk head connector then fuse box
You really need a multimeter to follow the voltage and look where it stops
https://www.clanmcmuffin.com/64%20Mustang%20Wiring%20Diagrams%20(Colorized).pdf
Link to schematic
Next voltage reg, bulk head connector then fuse box
You really need a multimeter to follow the voltage and look where it stops
https://www.clanmcmuffin.com/64%20Mustang%20Wiring%20Diagrams%20(Colorized).pdf
Link to schematic
9
Tech Torque Pre 1973 / Re: 67 S-code is dead - no electrical activity
« Last post by 6t9m1 on September 25, 2023, 08:46:10 pm »Solenoid wiring may be wrong.
Post a picture so we can check.
The big post on the solenoid that is connected to the battery should also have a smaller wire that connects into wiring loom note these wires should be on the same post.
The other post will send power to the starter.
Post a picture so we can check.
The big post on the solenoid that is connected to the battery should also have a smaller wire that connects into wiring loom note these wires should be on the same post.
The other post will send power to the starter.
10
Tech Torque Pre 1973 / 67 S-code is dead - no electrical activity
« Last post by gavin57 on September 25, 2023, 07:42:52 pm »Looking for advice - I have a 67 S-code that is completely dead. Motor won't crank, no lights, no horn, no dash lights.
Battery is near new and has tested good, starter solenoid has been checked and is good (bypassing the ignition switch has the engine cranking over.
No volts from the ignition switch when it is turned on.
My guess is ignition switch is faulty but the lights and horn etc not working is confusing me.
Any thoughts/suggestions?
Battery is near new and has tested good, starter solenoid has been checked and is good (bypassing the ignition switch has the engine cranking over.
No volts from the ignition switch when it is turned on.
My guess is ignition switch is faulty but the lights and horn etc not working is confusing me.
Any thoughts/suggestions?