Mustang Owners Club Australia Forum

Technical & General Discussion Area => Mustang Chat Room => Topic started by: Giffo on May 03, 2021, 06:35:44 pm

Title: HALF DRIVE SHAFTS - REBUILD
Post by: Giffo on May 03, 2021, 06:35:44 pm

Is there anyone that knows who can rebuild drive half shafts in Sydney?  I have the 2001/2 Mustang Cobra with IRS rear end.

cheers

Title: Re: HALF DRIVE SHAFTS - REBUILD
Post by: sms777 on May 05, 2021, 07:35:16 pm

I have used A&L Driveshafts in Belmore for over 20 years. Very fast and cheap. Call Tony on 9787 1655.

Title: Re: HALF DRIVE SHAFTS - REBUILD
Post by: Giffo on May 06, 2021, 05:25:21 pm

Thanks. Will call them soon.

 :thumb:

Title: Re: HALF DRIVE SHAFTS - REBUILD
Post by: jiffy on May 07, 2021, 09:33:21 am

Hi Steve - seriously, you've worn out your half-shafts??

I'm still going on with the originals - what was the symptom that alerted you?

Title: Re: HALF DRIVE SHAFTS - REBUILD
Post by: Giffo on May 08, 2021, 09:55:53 pm

Ever since I put in new diff and gears I have had a rear vibration in the rear over 80 plus kph. Load and not. Tail shaft balanced after checking wheel balance. Whole rear end was new. Im lost as to what it may be. Half shafts is all I can think of. Going to jack it up and check the torque settings on the half shafts when I get a chance, The diff mob said all good their end?? Process of elimination really.

Quote from: jiffy on May 07, 2021, 09:33:21 am

Hi Steve - seriously, you've worn out your half-shafts??

I'm still going on with the originals - what was the symptom that alerted you?