Mustang Owners Club Australia Forum
Technical & General Discussion Area => Technical - General => Topic started by: 65coupe on November 02, 2010, 10:00:35 am
-
Been looking around for some ideas on drilling out spot welds on panels and some say to use a spot weld drill bit and some say normal bit will do? Where is a good place to get a spot weld bit and how much would I be looking at to buy? Thanks in advance
-
Hi 65coupe,
Try 'Blackwoods' or Auto One if you have them within your area/suburb.
The last time we had used one, I think they came in at around the $45 + mark...
Cheers,
Trans-Am:cool:
-
I bought this one of Ebay, works great. Make sure you get extra blades.
http://cgi.ebay.com.au/HSS-3-8-10mm-ROTARY-SPOT-WELD-WELDER-DRILL-CUTTER-/270657140055?pt=AU_Car_Parts_Accessories&hash=item3f046c3557
-
Cool, might give them a try.. How many extra blades did you order?
-
just the 3 but in hindsight I would have ordered an additional 3. I suppose it depends on how many spot welds you have to do
-
Got to do the cowl panel. But can't order the part till work pays me the 500 they owe me.
-
http://crashsupplies.com/csv/
I got mine here. about $28 from memory.
-
Got it from A&A near work in bayswater for 27..
-
+1 for crash supplies