Mustang Owners Club Australia Forum
Technical & General Discussion Area => Tech Torque Pre 1973 => Topic started by: motiv on June 03, 2023, 08:13:03 pm
-
Hi,
I would like to make hood scoop functional on my 69 as a cold air intake.
Would anyone out there have a hood with the factory Pie-Cut openings in it that I could get measurements from?
I know it's a long shot, but worth asking.
Have looked at the few pictures on the net, but most of them have been taken at an angle so not possible to get accurate measurements.
Motive
-
Hey Motive,
If you google “pie cut hood 69 mustang” you’ll find what you’re after!
For some reason I couldn’t copy the link!
Hope it helps.
But, I have a 68 with a GT bonnet and I find the open bonnet a pain because when you wash your car the detergent and water spray all over the engine creating water spots.
Cheers Phil.