Mustang Owners Club Australia Forum
Technical & General Discussion Area => Tech Torque Pre 1973 => Topic started by: mswyld on June 07, 2006, 02:43:16 pm
-
currently have a 289 windsor with a 3spd manual (has the old style clutch linkages through the firewall) and is left hand drive!
I was looking at getting the motor reco'ed......
but stumbled across a 289 windsor with a 4spd manual out of a za fairlane which has not long been done up has roller rockers edelbrock bits etc etc
what would i need to change in order to fit the 4spd and motor:
tailshaft?
clutch manual linkages?
or would it slot straight in?
THANKS IN ADVANCE!
-
You will not need to change absolutely anything else, It should all line up as if you are refitting the 289 with the 3 speed.