Okay now the vacuum lines. The one with the white stripe that comes from the actuator pops out through the centre of the fire wall and plugs into a three way valve seperator .
The hose to the left of the black white stripe hose goes to the cannister & the one I'm holding goes to the inlet manifold.
Hi P8triot - these photos are FANTASTIC!
Wow - I think I have it pretty much right - a couple of things I need to go check though - I'm not sure I have the power feed wire going off to that 3-way power block - I'll have to go check.
Interestingly, I don't have that 3-way vacuum splitter valve thingy. I "think" (assumed) it was in the actual vacuum canister itself.
My canister has two vacuum hose fittings:
I'm wondering if this little valve is incorporated into the canister?
As far as the hoses go, well - I thought that one came from the intake manifold, and the other went to the vacuum motor on the steering column.
I followed this diagram that I found on the West Coast Classic Cougar forum:
Can you please confirm how many vacuum hoses your vacuum canister under the battery tray has going to it - 1 or 2??
That would probably make diagnosis of this setup a little easier.