Technical & General Discussion Area > Tech Torque Pre 1973

67 289 Radiator

(1/2) > >>

Michael:
Hi All, Well I have everything ready for my 6 to 8 conversion except for a radiator. Does anyone know if there is a Radiator than can be used for a conversion. I am after a 3 or 4 row. I do not want to modify the radiator support panel/rails. It appears to be a double flange set up. I have tried a couple of radiator shops and they can do the core but not the tanks or straps etc. Also a pair of hoses would be handy. I know the falcon xp fits the old 200cu but unsure on the 289.

Regards

Michael

Pete:
Buy a 3 row radiator from an XR/XT Falcon, top outlat should be on drivers side (RHD) and bottom inlet on pass side. These are available from most good radiator suppliers and are a close match to the original Mustang radiator. Good Luck.

Homer:
XW & XY are the same too !!!





Aren't they??

Michael:
Sorry guys forgot to mention that the one I am after is the standard radiator. Inlet and outlet are on the same side as each other(Passenger Side - (LHD))

if the XR,XT or XY XW radiator can be used, will these be cross flow and do you know if hoses that will fit and clear be purchased also.

Regards

Michael

Homer:

--- Quote ---Originally posted by Michael
Sorry guys forgot to mention that the one I am after is the standard radiator. Inlet and outlet are on the same side as each other(Passenger Side - (LHD))

if the XR,XT or XY XW radiator can be used, will these be cross flow and do you know if hoses that will fit and clear be purchased also.

Regards

Michael
--- End quote ---



(Passenger Side - (LHD) hmm
 both my outlets are on the right hand side, drivers side on a right hand drive car, battery side, 302 windsor,

what sort of motor do you have ??

Navigation

[0] Message Index

[#] Next page