Pushrod length.

[skev]

Or a case of Budweiser. I think with the ones with the ball on they are to give clearance on very high lift cams, which I don't have. I'll get the one piece 5/16 ones at about 200.00

[barnett468]

Or a case of Budweiser.

ummm, we actually call that "Butwiper" in the us because it gives one the runs.

I think with the ones with the ball on they are to give clearance on very high lift cams...

please dont think . . they are simply a cheap way to build them . . i assure you that john force does not have ball end push rods.

[skev]

Ok, will try to avoid thinking.

[barnett468]

Ok, will try to avoid thinking.

sorry...couldn't help myself. 

did you try vpw warehouse yet?

[skev]

Yes, they have what I want for 201.00

[barnett468]

Yes, they have what I want for 201.00

ok, thats maybe $150.00 usd which is not a bad deal . . ALSO, if you cry a little or tell them rocket racing will sell them for $18.00 less, they will likely take a few dollars off.

[skev]

Pushrods on the way, ordered a one inch phenolic spacer too. May need to change my heater inlet elbow because I think they'll conflict now. Will check when I get off this yacht. Sailing in the Whitsundays is not a bad way to pass the time but I'd like to get my engine back together.

[barnett468]

Will check when I get off this yacht. Sailing in the Whitsundays is not a bad way to pass the time but I'd like to get my engine back together.

I...I...just don't know what to say.