Technical & General Discussion Area > Members Cars
Time to start my rebuild project
pgold:
looking awesome Lee
jiffy:
Great thread - any updates, or are you too busy out driving it??
LEE H 69:
Hi Jiffy, Nah ! not out driving it just yet, had it on the Dyno to finish tune the engine, didn't go as planned, done a couple of runs then had a seized Hydraulic lifter ( new)...so pulled the injection off, replaced the lifter then back on Dyno, couple more runs then blew a head gasket, So I decided to pull the motor out do a complete strip down check everything and rebuild it again, The first couple of pulls show about 700 ft/lbs of torque, so she has plenty of potential ..
https://youtu.be/fQKP3iEd8xU
jiffy:
Far out - it wasn't tied down well on the dyno, was it???
Sorry to hear about the lifter/head gasket issue!
LEE H 69:
funny thing was after that one we pulled the straps down tighter, and ended up with wheel spin on the rollers.....can't win...lololol
Navigation
[0] Message Index
[*] Previous page
Go to full version